1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Thank You to everyone that Planned, Attended, Demonstrated, Volunteered and Traveled to be a part of a very successful Symposium.
    We hope you are inspired to make new Ornamental Turnings!
    Dismiss Notice

New Rosette Source For MDF RE

Discussion in 'The MDF Rose Engine' started by George Balock, Oct 3, 2018.

Tags:
  1. George Balock

    George Balock New Member

    I recently got a bunch of new rosettes from Wade over at Mandala Rose Works http://www.mandalaroseworks.com/site/home that are setup for the MDF rose engine with appropriate phasing holes and slots for the hold down screws. He has two sets of rosettes. I got set 1. He makes them out of 1/4” acrylic and are laser cut.

    I made a couple of 1/4” washers to go between the main pulley and the rosette to keep the spacing the same as the 1/2” rosettes.
    So far, I am very pleased with the performance. Give them a try.
     
    Russell Williamson likes this.